Installation guide

27
DO
DON'T
Elbow highly
recommended
Do not use
excessive
exhaust
length
Do not place
appliance on
flexible
exhaust
Do not crush
flexible
exhaust
against wall
9. Dryer exhaust to right, left or bottom
BEFORE PERFORMING THIS EXHAUST INSTAL-
LATION, BE SURE TO DISCONNECT THE AP-
PLIANCE FROM ITS ELECTRICAL SUPPLY. PRO-
TECT YOUR HANDS AND ARMS FROM SHARP
EDGES WHEN WORKING INSIDE THE CABI-
NET. BE SURE TO WEAR GLOVES.
WARNING
For downward venting, rotate elbow
sections so that elbow points downward
C
H
• Rotate elbow sections so that the opening points to the side
to which you want to vent. Preassemble 4" elbow with 4"
duct. Use only 4" UL approved rigid metal for ducting in-
side the dryer.
• Connect duct assembly to the internal elbow.
Be sure not to pull or damage the electrical wires inside
the dryer when inserting the duct.
Internal duct joints must be se-
cured with tape, otherwise they
may separate and cause a
safety hazard.
• Apply duct tape as shown on the joint between the dryer
internal duct and the straight duct pipe.
WARNING
WARNING