Owner's Manual

54
B
*AIR GAP
DISHWASHER
HOSE
*Air gap may not be required
for all installations. Check local
plumbing codes.
RUBBER
HOSE
DISPOSER
A
KNOCK
OUT PLUG
Dishwasher Connection
If you are utilizing a dishwasher, complete the following procedure. If dishwasher is
not to be connected go to section Installation of Mounting Assembly.
A. Using a blunt instrument (steel punch or wooden dowl), knock out entire plug (see
A). Do not use a screwdriver or sharp instrument. When knockout plug falls into
disposer, you may remove it or simply grind it up when the disposer is used. This
will not damage the disposer in any way, but may take some time to grind over
the course of several uses. Go to section Installation of Mounting Assembly.
B. Connect dishwasher hose using hose clamp. If hose size is different, you will need
a Dishwasher Connector Kit (see B). Make sure all plumbing connections are tight
and in accordance with all plumbing codes and ordinances. Run water and check
for leaks.
Mounting Assembly
NOTE: Hush Cushion is included between mounting ring and lower mounting ring.
Stopper
Sink Flange
Fiber Gasket
Backup Flange
Mounting Ring
Screws
Snap Ring
Hush Cushion
Lower Mounting Ring
1
2
3
4
5
6
7
8
9
A
STOPPER*
SINK FLANGE**
SINK
RIDGE
SNAP RING
FIBER GASKET
BACKUP FLANGE
MOUNTING RING
PLUMBER’S
PUTTY
RESET BUTTON
* Batch Feed Stopper looks different than the stopper illustrated.
** Mount Assembly
RUBBER
GASKET
SINK FLANGE**
SINK
RIDGE
SNAP RING
FIBER GASKET
BACKUP FLANGE
MOUNTING RING
SCREWS
PLUMBER’S
PUTTY
** Mount Assembly
HUSH
CUSHION
®
LOWER
MOUNTING
RING