Instruction Manual

6
■ Installing the Antenna
Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and turning
it clockwise until secure.
Note: The antenna is neither a handle,
a key ring retainer, nor a speaker/
microphone attachment point. Using
the antenna in these ways may damage
the antenna and degrade your
transceiver’s performance.
Antenna
■ Installing the Belt Clip
If necessary, attach the belt
clip using the two supplied
3 x 8 mm screws.
Note:
◆ If the belt clip is not installed, its
mounting location may get hot
during continuous transmission or
when left sitting in a hot
environment.
◆ You must remove the belt clip
before removing the battery pack.
DO NOT USE GLUE WHICH IS DESIGNED TO PREVENT
SCREW LOOSENING WHEN INSTALLING THE BELT CLIP, AS
IT MAY CAUSE DAMAGE TO THE TRANSCEIVER. ACRYLIC
ESTER, WHICH IS CONTAINED IN THESE GLUES, MAY
CRACK THE TRANSCEIVER’S BACK PANEL.
Belt
clip