MONITOR WITH DVD RECEIVER DDX7019 DDX7039 INSTALLATION MANUAL © B54-4522-00/00 (KV/RV) DDX7019_B54-4522-00_3.indd 1 06.12.
Accessories 1 ..........1 2 ..........1 3 ..........2 4 ..........1 5 ..........1 6 ..........6 7 ..........6 8 ..........1 2 | DDX7019/DDX7039 DDX7019_B54-4522-00_3.indd 2 06.12.
Installation Procedure 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Make the proper input and output wire connections for each unit. 3. Connect the speaker wires of the wiring harness. 4. Connect the wiring harness wires in the following order: ground, battery, ignition. 5. Connect the wiring harness connector to the unit. 6. Install the unit in your car. 7. Reconnect the - battery. 8. Press the reset button.
Connection If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.
Rear view FUSE ( 10A ) Cooling fan FM/AM antenna input Accessory 1 ILLUMI FRONT L REVERSE White/Black White FRONT R REMO.CONT REAR L Gray P CONT + To front right speaker Green/Black Green REAR R To front left speaker Gray/Black MUTE ANT. CONT + + To rear left speaker Purple/Black Purple + To rear right speaker EXT.CONT English | DDX7019_B54-4522-00_3.indd 5 5 06.12.
System Connection USB terminal USB device (commercially available) Do not connect.
Optional Accessory Connection iPod (commercially available) Navigation System (Optional Accessory) KCA-iP300V (Optional Accessory) Audio Input iPod AUDIO IN Audio Output (Black) Connection cable (Included in the Navigation System) Visual Input iPod VIDEO IN Visual Output (Yellow) Rear view USB terminal USB terminal Connection cable (Included in the Disc changer) Disc Changer etc.
Installing the Escutcheon For General Motors 1. Refer to the section and then remove the hard rubber frame. 2. Cut out accessory 4 to meet the shape of the opening of the center console. 3. Attach accessory 4 to the unit. Cut out to meet the shape of the opening in the vehicle. Accessory 4 For Toyota/Scion 1. Refer to the section and then remove the hard rubber frame. 2. Cut out accessory 4 as illustrated. Cutting line Accessory 4 3.
Installation for Monitor/Player Unit Firewall or metal support Screw (M4X8) (commercially available) Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Self-tapping screw (commercially available) Metal mounting strap (commercially available) Accessory 2 Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip).
Removing Monitor/Player Unit Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 3 and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Removal Tool (Accessory 3) Removing the Unit 1. Remove the hard rubber frame by referring to the removal procedure in the section . 2. Remove the Hex-head screw with integral washer (M4 × 8) on the back panel. 3.