User Manual
English
|
27
7 Exit display control mode
Turn the [VOL] knob to select "Return".
Press the [VOL] knob.
• When you selected the Display Type B display, select
an easy viewable font color.
• The "Indicator" item of Display type C/D can be set;
however, the actual display color does not change.
• This function can be set for each display type.
• When the SIRIUS tuner source in the 1-item 4-rowc
mode of Display type C/D, the same color is set for
both the upper and lower rows.
Display Type E
G-Analyzer display Switching
Alternates G-Analyzer display when the Display
type is set to "Display Type E". (G: gravity)
• Never watch the G-Analyzer Display screen when you
are driving.
Otherwise, a car accident may result.
• Before alternating G-Analyzer display, you are required
to setup <G-Counter Level set> (page 47) and <G-
Analyzer Calibration setup> (page 48).
1 Show the Multi-function display
Press the [NEXT] button repeatedly until
"Display" appears.
Refer to <Notes on Multi-function System> (page
9).
2 Enter display control mode
Turn the [VOL] knob to select "Display".
Press the [VOL] knob.
3 Select the display mode
Turn the [VOL] knob to select "mode".
Press the [VOL] knob.
Select the "Display Type E" display.
4 Enter G-Analyzer display select mode
Turn the [VOL] knob to select "G-Menu".
Press the [VOL] knob.
5 Select the G-Analyzer display
Push the Control knob towards [4] or
[¢].
G-Analyzer display
G- Graphic display
ACCELERATION CORNERING
G-Meter display
Point
Time
G-Counter display
• G-Graphic display:
Displays the condition of G in horizontal direction (e.g;
when turning the curve) by the graphic.
• G-Meter display (Graphic part):
Displays the maximum value of acceleration G, right
direction G, and left direction G by the numerical
value.
G-Meter display (Text part):
The maximum value of acceleration G, right direction
G, and left direction G is displayed by the numerical
value. The value of G is only the reference, so is
different from the actual value.
• G-Counter display:
Adds the point of the acceleration level. The point is
determined after a lapse of 1 hr drive or at power off
(ACC Off), and then it will be displayed by the graph.
Furthermore, the G-Counter displays the average
of the past data by the line. (The scale of graph is
determined along with the largest point among the
past 10 data.)
• The value of G-Meter display and G-Counter display
can be reset by <G-Analyzer Reset> (page 47).
6 Exit display control mode
Turn the [VOL] knob to select "Return".
Press the [VOL] knob.
B64-3427-0000English.indd27B64-3427-0000English.indd27 06.2.25:12:11PM06.2.25:12:11PM