User Manual
7
INSTALLING THE OPTIONAL ANTENNA
INSTALLING THE BELT CLIP
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver.
Acrylic ester, which is contained in these glues, may crack the
transceiver’s back panel.
Screw the antenna into the connector on the
top of the transceiver by holding the antenna
at its base and turning it clockwise until secure.
Note: The antenna is neither a handle, a key
ring retainer, nor a speaker/ microphone
attachment point. Using the antenna in these
ways may damage the antenna and degrade your
transceivers performance.
If necessary, attach the belt clip using
the two supplied 3 x 8 mm screws.
Note: If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.