User Manual

30
To start scanning, momentarily press the key programmed as
either Scan or Scan + Temporary Delete.
• The LED indicator flashes green and scanning starts from the
current channel and ascends through the channel numbers.
• When a signal is detected on a channel and the QT/ DQT
matches, scan pauses at that channel and the LED indicator
lights green.
• When the signal is no longer present, scanning continues after 3
seconds (default).
To end Scan, press the Scan or Scan + Temporary Delete
key again.
■ Priority Scan
The Priority channel is a channel that is given first priority
to while scanning. The Priority channel is set by your
dealer.
During Scan, the transceiver will automatically change to
the Priority channel when a call is received on it, even if
a call is already being received on any of the other
channels.
■ Temporary Delete
You can temporarily remove specific channels from the
scanning sequence during Scan. When Scan pauses at a
channel, you can remove that channel from the scanning
sequence by pressing and holding the key programmed as
Temporary Delete or Scan + Temporary Delete for
1 second.
•You cannot remove a channel if there will be less than
2 channels available for scanning remaining.
•To add the removed channels back into the Scan list, simply
exit Scan mode or switch the transceiver power OFF and then
ON again.