- Kerio WinRoute Firewall Administrator's Guide

Chapter 16 Other settings
224
Definitions of Dynamic and Static Rules
Click on the Add (or Edit when a particular route is selected) button to display a dialog
for route definition.
Figure 16.2 Adding a route to the routing table
Network, Network Mask
IP address and mask of the destination network.
Interface
Selection of an interface through which the specific packet should be forwarded.
Gateway
IP address of the gateway (router) which can route to the destination network. The
IP address of the gateway must be in the same IP subnet as the selected interface.
Metric
“Distance” of the destination network. The number stands for the number of
routers that a packet must pass through to reach the destination network.
Metric is used to find the best route to the desired network. The lower the metric
value, the “shorter” the route is.
Note: Metric in the routing table may differ from the real network topology. It may
be modified according to the priority of each line, etc.
Create a static route
Enable this option to make this route static. Such route will be restored automat-
ically by WinRoute(see above). A brief description providing various information
(why the route was created, etc.) about the route can be attached.