User's Manual

WALNUT SINGLE COIL FAST WIRELESS CHARGER
胡桃木单线圈快速无线充电器
产品说明书 | User Manual
中文简体
产品简介
胡桃木快速充电器采用胡桃木CNC外壳，天然的木材质感和纹理加上简洁大方的外观设计，
最高支持Qi EPP 15W快速无线充电体验。实现符合Qi标准的移动数码设备全兼容，可以做到
“随放随充”的无线充电体验。
产品外观
使用说明
适用设备
1.将充电线的USB接口与电源适配器连接。
2.将USB充电线的Type C接口与无线充电器连接好，接通电源后，无线充电器指示灯会闪烁3次。
3.将支持无线充电的待充电设备放置于无线充电器上，即放即充。当设备开始充电时，充电指示灯
会根据充电功率保持绿色呼吸灯或蓝色呼吸灯。
(针对自动发射饱和信号的设备，设备充满后指示灯会自动熄灭，非所有设备充满后会自动灭灯)
4.当使用快速无线充电的无线充电设备时，需使用高通标准的QC2.0/QC3.0快充电源适配器。
符合Qi标准的数码设备都能兼容使用，更多的设备型号可自行到Qi官网查询。
配件清单
1.胡桃木单线圈快速无线充电器
2.USB充电线
3.用户手册
【注意事项】
1.请保持产品远离水和其他液体。
2.请在环境温度0-45℃下使用该产品。
3.请勿严重撞击、自行拆卸、修理、改造本产品。
4.请勿接触苯、稀释剂等腐蚀性化学药品。
产品参数
型号
输入
传输距离
输出
充电效率
产品尺寸
KSFWCP01
5V/2A 9V/2A 12/2A
≤6mm
5W/7.5W/10W/15W
（自适应输出功率，最高输出15W）
≤80%
87*87*10mm
English
Product Introduction
WALNUT FAST WIRELESS CHARGER uses a walnut CNC shell, natural wood texture and
texture, plus a simple and elegant appearance design, and supports up to Qi EPP 15W
fast wireless charging experience. It is fully compatible with Qi standard mobile digital
devices, and can achieve a wireless charging experience of "discharging and charging".
Product appearance
Instructions For Use
Applicable Devices
1.Connect the USB port of the charging cable to the power adapter.
2. Connect the Type C interface of the USB charging cable to the wireless charger. After the power
is turned on, the wireless charger indicator will flash 3 times.
3. Place the device to be charged that supports wireless charging on the wireless charger and charge
it immediately. When the device starts to charge, the charging indicator will remain a green breathing
light or a blue breathing light depending on the charging power.
(The indicator light will automatically turn off when the device that automatically emits a saturated
signal is full. Not all devices will automatically turn off when they are full)
4. When using fast wireless charging wireless charging equipment, you need to use Qualcomm
standard QC2.0/QC3.0 fast charging source adapter.
Digital devices that comply with the Qi standard can be compatible.
More device models can be checked on the Qi official website.
What's In The Box
1.Walnut single coil fast wireless charger
2.USB charging cable
3.User manual
【Attentions】
1. Please keep the product away from water and other liquids.
2. Please use this product at an ambient temperature of 0-45℃.
3. Do not severely impact, disassemble, repair, or modify this product by yourself.
4. Do not touch corrosive chemicals such as benzene and thinners.
Product Parameter
Model
Input
Transmission Distance
Output
Charging Efficiency
Product Size
KSFWCP01
5V/2A 9V/2A 12/2A
≤6mm
5W/7.5W/10W/15W
（Adaptive Output Power ，15W Max）
≤80%
87*87*10mm
4 3 2 1
QC2.0/QC3.0
指示灯
QC2.0/QC3.0
Light
4 3 2 1
QC2.0/QC3.0
QC2.0/QC3.0
Type C 电源输入口
硅胶防滑脚垫
充电指示灯
充电感应区域
Type C Power Input
Silicone Anti-Slip Mat
Charging Indicator
Charging Induction Area
LED状态提示
绿色呼吸灯
蓝色呼吸灯
绿色灯闪烁
蓝色灯闪烁
青色灯闪烁
过压保护
青色呼吸灯
5W充电
快速充电
过温保护
FOD保护
已充满
LED Status Prompt
Green Breathing Light
Blue Breathing Light
Green Light Flashing
Blue Light Flashing
Cyan Light Flashing
Overvoltage Protection
Cyan Breathing Light
5W Charging
Fast Charging
Over Temperature Protection
FOD Protection
Fully Charged
【FCC Warning】
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance between 20cm the radiator your body.
【FCC 警告】
本设备符合 FCC 规则的第 15 部分。操作受以下两个条件的限制：
(1) 本设备不会造成有害干扰。
(2) 本设备必须接受接收到的任何干扰，包括可能导致意外操作的干扰。
任何未经合规责任方明确批准的更改或修改都可能使用户操作设备的权限失效。
根据 FCC 规则第 15 部分，本设备已经过测试并符合 B 类数字设备的限制。这些限制旨在提供合
理的保护，防止住宅安装中的有害干扰。本设备会产生用途并可辐射射频能量，如果未按照说明
安装和使用，可能会对无线电通信造成有害干扰。但是，不能保证在特定安装中不会发生干扰。
如果此设备确实对无线电或电视接收造成有害干扰，可以通过关闭和打开设备来确定，鼓励用户尝
试通过以下一项或多项措施来纠正干扰：
- 重新调整或摆放接收天线。
- 增加设备和接收器之间的距离。
- 将设备连接到与接收器所连接的电路不同的电路上的插座。
- 向经销商或有经验的无线电/电视技术人员寻求帮助。
FCC 射频暴露声明：
该设备符合针对不受控制的环境规定的 FCC 辐射暴露限制。本设备的安装和操作应与您身体的散
热器之间的最小距离为 20 厘米。