Use and Care Manual

ManualsBrandsKeystone ManualsHeating, Ventilation, and Air Conditioning12 in. Oscillating Pedestal Fan with Remote Control in Black

Instruction Manual

ETLus Electric Fan

KSTFA120AG

For Household Use Only

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

This fan has a polarized plug (one blade is wider than the other). To reduce the

risk of electric shock, this plug is intended to fit in a polarized outlet only one way.

If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,

contact a qualified electrician. Do not attempt to defeat this safety feature.

This product employs overload protection (fuse). A blown fuse indicates an

overload or short-circuit situation. If the fuse blows, unplug the product from the

outlet. Replace the fuse as per the user servicing instructions (follow product

marking for proper fuse rating) and check the product, If the replacement fuse

blows, a short-circuit may be present and the product should be discarded or

returned to an authorized service facility for examination and/or repair.

WARNING – To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This

Fan With Any Solid-State Speed Control Device.

WARNING – To Reduce The Risk Of Electric Shock, Do Not Expose to Water

or Rain.

WARNING – This is a fan – not a toy! To reduce the risk of personal injury and

electric shock, it should not be played with or placed where small children can

reach it.

When using electric appliances, basic safety precautions should always be

followed, including the following:

1. Do unplug or disconnect the appliance from the power supply before servicing.

2. Do not use gasoline, thinners, solvents, ammonias or other chemicals for

cleaning.

3. Do clean your fan regularly. Refer to the Cleaning instructions provided. Never

clean the fan in any manner other than as instructed in this manual.

4. Do not operate any fan with a damaged cord or plug. Discard fan or return to

an authorized service facility for examination and/or repair.

5. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,

or similar coverings. Do not route cord under furniture or appliances. Arrange

cord away from traffic area and where it will not be tripped over.

6. Do not use this product outdoors.

7. Do not use this product on wet surfaces.

8. Do not use this product in a bathtub or shower.

9. Do not use near furnaces, fireplaces, stove or other high-temperature heat

sources.

10. Do not immerse this product in water or allow water to drip into the motor

housing.

11. Do not position this fan too close to draperies because they may be drawn into

the rear guard, cutting off airflow.

SAVE THESE INSTRUCTIONS

User Servicing Instructions

P1-14606

P2-14606

Summary of content (5 pages)

PAGE 1
outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product, If the replacement fuse blows, a short-circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair. Instruction Manual ETLus Electric Fan KSTFA120AG WARNING – To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-State Speed Control Device.
PAGE 2
Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord. Open fuse cover (A.) by sliding access cover on top of attachment plug towards blades. Remove fuse carefully (B.) by gently prying out the ends of the fuse from the receptacle. Parts and Their Function Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse. Install replacement fuse (C.
PAGE 3
CAUTION: Do not insert the plug into the power point before assembly is complete. (May cause electric shock or injury) Do not press height adjustment button while fan and fan guard are detached. (The motor section (slide pipe) may jump out of stand, causing injury) ●Couple protrusions (three) on the motor section to concaves (three) on the rear guard. ●Fix them firmly by turning the guard fixing ring toward [fasten].
PAGE 4
How to Operate Maintenance and Storage WARNING    When cleaning, the plug must be removed from the power point. Do not handle plug with wet hands. [May cause electric shock or injury.] Do not press the height adjustment button while the fan and fan guard are detached. [The motor section (slide pipe) may jump out of the stand part, causing injury.] When disassembling the base or stand, unplug plug from the power point. [May cause electric shock or injury.
PAGE 5
1. Put the motor shaft upward, then unscrew fixing ring by turning anticlockwise. (Refer to the drawing at below) Holding the base firmly, then pull the base. CAUTION:   If the motor shaft is facing downward, the fan will become unstable and may damage the product or floor. When putting the motor shaft down, the fan is unstable. May cause machine failure and damage to floor. 2. Hold the stand firmly and gently lift and remove the base.