Installation Guide

4
Fig. 6
Mounting screws
(supplied with
electrical box)
Hook
Ceiling
mounting
bracket
UL Listed
outlet box
120V Wires
Washers
Cross pin
Hanger
ball
Set screw
Fig. 5
Supply wires
Downrod
Retaining pinHitch pin
Set screws
Coupling
Set screws
Hatteras Bay
TM
Patio
NOTE: This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling installation using a downrod and
canopy mounting system and a "close to
ceiling" Canopy ONLY system. The
"close-to-ceiling" installation is recommended
in rooms with less than 8-foot ceilings or in
areas where additional space is desired from
the floor to the fan blades. Once you have
selected which mounting system you will use,
proceed with the following instructions. Where
necessary, each section of the instructions will
note the different procedures to follow for the
two types of mounting.
REMEMBER to turn off the power before you
begin.
To properly install your ceiling fan, follow the
steps below.
Step 1. Pass the 120 volt supply wires from
the ceiling outlet box through the center of the
ceiling mounting bracket. (Fig.5)
Step 2. Attach the ceiling mounting bracket to
the outlet box using the screws and washers
included with the outlet box. (Fig. 5)
Step 1. Remove the hanger ball from the
downrod assembly by loosening the set screw,
removing the cross pin and sliding the ball off
the rod. (Fig.6)
Step 2. Loosen the two set screws and
remove the hitch pin and retaining clip from
the coupling on top of the motor assembly.
(Fig. 6)
Step 3. Carefully feed the electrical lead wires
from the fan up through the downrod. Thread
the downrod into the coupling until the Hitch
pin holes are aligned.
5. HANGING THE FAN
STANDARD CEILING INSTALLATION
Canopy
Canopy cover
Coupling cover