Installation Guide

5
Fig. 8
Fig. 7
Registration slot
Fig. 9
Check tab
Hook
Canopy
Decorative
mounting
screw
cover
Screws and Lock washers
(3 of 6 places)
Coupling
Next, replace the hitch pin and retaining clip.
Tighten both set screws. (Fig. 6)
Step 4. Slip the coupling cover, canopy cover
and canopy onto the downrod.
Thread the hanger ball onto the downrod,
insert the cross pin through the downrod and
tighten. Now tighten the set screw. (Fig. 6)
Step 5. Lift the motor assembly into position
and place the hanger ball into the ceiling
mounting bracket.
Rotate the entire assembly until the "Check
Tab" has dropped into the "Registration Slot"
and seats firmly. (Fig. 7)
The entire motor assembly should not rotate
(left or right) when seated properly.
WARNING: Failure to properly seat the
"Check Tab" can damage the ceiling fan
during operation.
Step 1. Remove three of the six screws and
lock washers (every other one) from the collar
on top of the motor assembly. Place the ceiling
fan canopy over the collar and align the
mounting holes with the holes in the collar.
Attach the canopy with the three screws and
lock washers previously removed. (Fig. 8)
WARNING: Failure to completely tighten the
three mounting screws in step 1 could result in
the fan possibly falling from the ceiling.
Step 2. Push the decorative mounting screw
cover down and off the canopy letting it rest on
top of the motor housing (Fig. 8) and hang the
fan on the mounting bracket by inserting the
hook on the inside edge of the mounting
bracket through one of the screw holes in the
ceiling canopy. (Fig. 9) This will allow you to
have both hands free to make the wiring
connections.
CLOSE-TO-CEILING INSTALLATION