Installation Guide

9
Fig. 18
Fig. 19
Step 1. Install 4, 40W T3 halogen bulbs
(provided). (Fig. 19)
Step 2. Loosen the 4 screws on the glass lens
(do not remove). Raise the glass lens against
the light fixture and align the key holes of the
light fixture with the screws of the glass lens,
turn the glass lens clockwise until it locks in
place at the narrow section of the key hole
slots.
Secure the glass lens to the light fixture by
tightening the 4 screws. (Fig. 19)
12. INSTALL THE LIGHT BULBS
Step 1. Loosen the three mounting screws on
the inside of the light fixture.
Hold the light plate close to the light fixture and
connect the white wires from the light plate
and the fan. Follow the same procedure with
the black wire connectors. (Fig. 18)
Tuck the connections neatly into the light
fixture.
NOTE: Be careful not to pinch the light plate
wires between the light plate and the light
fixture.
Place the light plate key holes over the three
mounting screws inside the light fixture and
turn the light plate until it locks in place at the
narrow section of the key hole slots. Secure by
tightening all three screws. (Fig. 18)
11. INSTALLING THE LIGHT KIT
Light plate
Wire connectors
Light fixture
Mounting screws
Glass lens
Light fixture
Light plate
Bulbs
Screws