Instructions / Assembly

5
Fig. 9
Fig. 10
Registration slot
Downrod
Canopy
Canopy cover
Coupling cover
Step 7. Slip coupling cover, canopy ring and
canopy onto downrod. Carefully reinstall
hanger ball onto rod being sure that cross pin
is in correct position, the set screw on hanger
ball is tight and wires are not twisted. (Fig. 9)
Step 8. Now lift the motor assembly into
position and place the hanger ball into the
hanger bracket. Rotate until the "Check Tab"
has dropped into the "Registration Slot" and
seats firmly. (Fig. 10). The entire motor
assembly should not rotate if this is done
correctly.
Set screws
Hitch pin
Lock pin