Instructions / Assembly

9. ATTACHING THE FAN BLADES
Fig. 14
Fig. 15
CAUTION: Remove the five rubber shipping
blocks attached to the face of the motor.
These blocks keep the motor from shifting
during shipping and MUST be removed during
installation.
Step 1. Attach a blade to a blade bracket
using the screws and fiber washers provided.
(Fig. 14)
Make sure the blade is straight when set on
the blade bracket. Tighten each mounting
screw until the fiber washer is slightly
compressed. Repeat this procedure for each
blade.
Step 2. Attach each blade assembly to the
motor using the "Pre-Installed" mounting
screws in the blade bracket. (Fig 14)
Screws
Blades
Blade brackets
Screws
Fiber
washers
10. INSTALLING THE MOUNTING PLATE
1. Loosen the two screws on the mounting
ring attached to the motor shaft and "remove"
and save the third screw. (Fig. 15)
2. Place the key holes on the mounting plate
over the 2 screws previously loosened from
the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 15)
Mounting
plate
Mounting ring
Screws
8
42" Bowen