Installation Guide

STEM DROP INSTALLATION
1) Rotate arms until evenly spaced. (60degrees)
2) Pass fixture wire through clear acrylic trim.
3) Pass wire through stem. Screw stem to acrylic trim
4) Pass wire through remaining stems and screw together.
5) Pass wire through swivel and canopy.
6) Screw swivel and tube together.
7) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your
home. Place the main power switch in the “OFF” position.
b) Unscrew the fuse(s), or switch “OFF” the circuit breaker
switch(s), that control the power to the fixture or room
that you are working on.
c) Place the wall switch in the “OFF” position. If the fixture
to be replaced has a switch or pull chain, place those in
the “OFF” position.
8) Find the appropriate threaded holes on mounting strap.
Assemble mounting screws into threaded holes.
9) Attach mounting strap to outlet box. (Screws not provided)
Mounting strap can be adjusted to suit position of fixture.
10) Grounding instructions: (See Illus. A or B).
A) On fixtures where mounting strap is provided with a
hole and two raised dimples. Wrap ground wire from
outlet box around green ground screw, and thread into hole.
B) On fixtures where a cupped washer is provided. Attach
ground wire from outlet box under cupped washer and
green ground screw, and thread into mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector.
After following the above steps. Never connect
ground wire to black or white power supply wires.
11) Make wire connections. Reference chart below for correct
connections and wire accordingly.
12) Push fixture to ceiling, carefully passing mounting screws
through holes in canopy.
13) Thread threaded balls onto mounting screws. Tighten
threaded balls to secure fixture to ceiling.
14) Insert recommended bulbs.
GREEN GROUND
SCREW
CUPPED
WASHER
A
B
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
(NOT PROVIDED)
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
Date Issued: 3/08/16 IS-43808-US
SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.
MOUNTING SCREWS
TORNILLO DE MONTAJE
WIRE NUTS
TUERCAS PARA
ALAMBRE
CANOPY
CAPUCHÓN
STRAP MOUNTING SCREWS
TORNILLO DE MONTAJE
DE LA ABRAZADERA
STEM DROP INSTALLATION
INSTALACIÓN DE GATO DE VÁSTAGO
BALL KNOB
PERILLA REDONDA
STEM
VÁSTAGO
NIPPLE
NIPLE (MANGUITO)
CLEAR ACRYLIC TRIM
ADORNO DE ACRÍLICO CLARO
NIPPLE
NIPLE (MANGUITO)
WIRE BODY
ALAMBRE
GLASS ARM
BRAZO DE VIDRIO
CANDLE SLEEVE
CAMISA DE LA VELA