Warranty

FIGURE 5 SELECT CORRECT MOUNTING HOLES ON TRIM RING
TAMPER RESIST LOCKING PIN: To make your smoke alarm tamper
resistant, a locking pin has been provided with your alarm. Using
this pin will help deter children and others from removing the
alarm from trim ring. To use the pin, insert it into the hole in the
side of the alarm after the alarm has been installed on the trim
ring (see figure 8). NOTE: The tamper resist pin will have to be
removed in order to change the batteries. Use long nose pliers to
pull the pin out of the hole. It is now possible to remove the alarm
from the trim ring.
After installation, TEST your alarm by pressing and holding the test
button for several seconds. This should sound the alarm and acti-
vate the Safety Light.
4. OPERATION AND TESTING
OPERATION: The smoke alarm is operating once a fresh battery is
installed and testing is complete. When products of combustion
are sensed, the unit sounds a loud 85db pulsating alarm until the
air is cleared.
Rectangular
Plaster Ring
Circular
Plaster Ring
Octagonal
Electrical Box
To remove AC
connector,
squeeze
locking
arms and
pull.
Tamper resistant
locking pin
Alignment Marks
Remove
Install
FIGURE 6 FIGURE 7 FIGURE 8