User's Manual
Applying the cuff
2~3cm
1.
Hold your arm with your palm facing
up and tie the cuff on your upper arm,
align the Artery indicator with the
main Artery (on the inside of your arm).
Note: Locate the main Artery by pressing with
2 fingers approximately 2 cm above the bend
of your elbow on the inside of your left arm.
Identify where the pulse can be felt the
strongest, that is your main Artery！
4.
Make sure the bottom edge of the
arm cuff is 2 to 3 cm above the inside
elbow. Then wrap the cuff securely.
Note: The cuff should be snug but not too tight.
You should be able to insert one finger between
the cuff and your arm.
Remove all jewelry, such as watches
and bracelets from your left arm.
Note: If your doctor has diagnosed you with poor
circulation in your left arm, use your right arm.
Roll or push up your sleeve to expose
the skin. Make sure your sleeve is not
too tight.
2.
3.
5.
6.
Sit upright in a comfortable chair with
your back against the backrest of the
chair. Keep your feet flat and your legs
uncrossed.
Place your arm resting comfortably on
a flat table. The cuff worn on your arm
should be placed at the same level as
your right atrium of the heart.
Take 5-6 deep breaths and let's start
measuring!
Take the measurement in a silent room.
Wait at least 3 minutes before another measurement. This allows your blood circulation to recover.
Be relax and do not move and talk during the measurement procedure.
For a meaningful comparison, try to measure under similar conditions. For example, take daily
measurements at approximately the same time, on the same arm, or as directed by a physician.
Rest for 5 minutes before a measurement.
Helpful tips:
Cuff wrap detection
Display user ID
Start a measurement
2.
You can use your monitor without pairing to a smart device. To pair your
monitor with a smart device refer to the foregoing chapters.
1.
When the monitor is off, press the button, the current user ID
will flash.
Remain still and do not talk until the full measurement is complete.
(Example shown below for User 1)
Note
Any time, to stop the measurement, press the button.
Inflating and measuring
(a heartbeat is detected)
Display and save
the measurement result
15
MEASUREMENT MEASUREMENT
14