Full Product Manual

Avoid bouncing and snagging the accessories, especially when working corners,
sharp edges, etc. This can cause loss of control and kickback.
If the grinder becomes jammed or bogged down in the work piece, turn the tool off
by the switch. Wait for the spinning accessory to stop and unplug the tool, then work to
free the jammed material. If the switch is left on, the grinder could restart unexpectedly
causing serious injury.
Do not leave a running tool unattended; turn power off. Only when the accessory on
the grinder comes to a complete stop is it safe to put down.
Do not grind or sand near flammable materials. Sparks from the wheel could ignite
these materials.
W A R N I N G ! Do not use the unit on materials which contain asbestos.
Do not alter or misuse tool. Any alteration or modification is a misuse and may result in
serious personal injury. This product is not intended for use as a dental drill or in medical
applications. Serious personal injury may result.
Merlin2
®
miniature long neck angle grinders are available in both fixed speed and variable
speed models for 110V- 115V and 220V-230V.
The following chart easily identifies your Merlin2
®
power unit model.
SPECIFICATIONS
VARIABLE SPEED 110-115 VOLT
Merlin2
®
Model 10005: Universal
Carving Set - Voltage 110V-115V
60Hz Power 1.0 amp/100 Watt
Rotational Speed: 0 to 13,000 rpm
Disc Diameter: 2”/ 50mm
Length: 11-13/32”/280mm
Weight: 1.54 lb/700 grams
FIXED SPEED 110-115 VOLT
Merlin2
®
Model 10030: Universal
Carving Set 110V-115 V
60Hz 1.0 amp/100 Watt
Rotational Speed: 13,000 rpm
Disc Diameter: 2”/ 50mm
Length: 11-13/32”/280mm
Weight: 1.54 lb/700 grams
VARIABLE SPEED 220-240 VOLT
Merlin2® Model 10040: Universal
Carving Set - Voltage 220V-240V
50hz Power 1.0 amp/100 Watt
Rotational Speed: 0 to 13,000 rpm
Disc Diameter: 2”/ 50mm
Length: 11-13/32”/280mm
Weight: 1.54 lb/700 grams
FIXED SPEED 220-240 VOLT
Merlin2
®
Model 10041: Universal
Carving Set - Voltage 220V-240V
50hz Power 1.0 amp/100 Watt
Rotational Speed: 13,000 rpm
Disc Diameter: 2”/ 50mm
Length: 11-13/32”/280mm
Weight: 1.54 lb/700 grams
W AR N I N G !
Disconnect the plug from the mains before replacing any accessories.
Never press the locking button if the accessory is still rotating.
• Press the locking button 1 (FIG 3)
• Turn the fastening screw 4 counter clockwise using an Allen Key 5 until the
locking button engages.
• Undo the fastening screw 4, remove the centering disc 3 and the accessory.
• Fit the new accessory and ensure it is properly seated in the centering disc
shoulder 3.
• Press locking button 1 and secure, but do not over-tighten the fastening screw 4
using the Allen Key 5 in a clockwise direction.
REPLACING ACCESSORIES
FIGURE 3
7
10