Installation & Assembly

ManualsBrandsKing Canopy ManualsCarportsUniversal 10.5 Ft. x 20 Ft. Canopy

2-N-1 Expandable

™

12ft X 20ft / 20ft x 20ft

19ft7in Wide x 20ft Deep x

10ft3in Center Height (12x20) / 11ft7in Center Height (20x20)

King Canopy Item #: EX1220

With 8 Legs, Cover with Leg Skirts (12x20 and 20x20), Foot Pads,

Elastic Ball Straps and Center Leg Straps.

WARNING:

Keep all ame and heat sources

away from this tent fabric. Meets

the ammability requirements of

CPAI-84 . It is not re proof. The fabric

will burn if left in continuous contact

with any ame source.

Distributed by:

PIC America, LTD.

1730 Five Points Lane • Fuquay-Varina, NC 27526

1-800-800-6296 • www.kingcanopy.com

Summary of content (9 pages)

PAGE 1
2-N-1 Expandable™ 12ft X 20ft / 20ft x 20ft 19ft7in Wide x 20ft Deep x 10ft3in Center Height (12x20) / 11ft7in Center Height (20x20) King Canopy Item #: EX1220 With 8 Legs, Cover with Leg Skirts (12x20 and 20x20), Foot Pads, Elastic Ball Straps and Center Leg Straps. Distributed by: PIC America, LTD. 1730 Five Points Lane • Fuquay-Varina, NC 27526 1-800-800-6296 • www.kingcanopy.com WARNING: Keep all flame and heat sources away from this tent fabric. Meets the flammability requirements of CPAI-84 .
PAGE 2
PARTS LIST 6X3-2PC1 8 pc (A) 77.5” x 2” Pipes 6x3-2PC2 8 pc (B) 77.5” x 2” Double Swedge Pipes 6x6-15PC 9 pc (C) 77.5” x 1.
PAGE 3
FRAME ASSEMBLY Decide which canopy size you would like to assemble, 12ft x 20ft or 20ft x 20ft, and lay out the parts according to the diagrams below. The large diameter pipes are used to form the roof rafter and the small diameter pipes are used to form the length of the canopy. Set aside eight (A) 77.5 inch large diameter pipes for the legs. Note: Connect pipe together starting with the center peak of frame, then roof rafters and then sides of frame.
PAGE 4
PREPARING COVER FOR FRAME Using the diagram below choose the cover parts to assemble the cover to fit the frame size you have assembled. All cover parts are labeled. The A and B labeled sides of top are used with either the 12ft wide or the 20ft wide cover. Make sure the labels are at the same ends of frame before zipping the cover together. Please Note: The center section of cover will zip from opposite ends when labels are correct and at one end of frame.
PAGE 5
ATTACHING COVER WITH BALL STRAPS Step 1 When the cover has been assembled the leg skirts should be at each corner. The flared leg skirts should be over each of the corner slip-in fittings where the legs will be inserted. (Attachment of these valances will be discussed later). Fold the leg skirts and A-frame ends of the cover back over the top and begin attaching the cover with the elastic ball straps.
PAGE 6
LEGS ASSEMBLY NOW, CONNECT THE LEG POLES TO THE ROOF ASSEMBLY WITH THE COVER ALREADY POSITIONED ON TOP OF THE UNIT. (The diagram below illustrate the underside of cover with the grommet holes. The leg valances and A-Frame ends are not shown in illustration.) Step A: First insert the pipes for the middle poles into the 3- and 4-way connectors, and then connect the end leg pipes in the same way. (See illustration) The leg pipes are the (A) 75.25in pipe with single swedge end.
PAGE 7
ANCHORING YOUR UNIT This canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE securely anchored to the ground to prevent damage from winds. Your canopy will act like a kite in the wind if not properly and securely anchored to the ground. Severe winds will cause the frame to twist and unanchored legs will fall, thereby collapsing the canopy. If severe winds are expected, you must remove the cover from the frame to prevent damage.
PAGE 8
IMPORTANT NOTICE: PLEASE READ CAREFULLY We are confident that you will be completely satisfied with your King Canopy unit. Please take a moment to read the very important information below, and call us with any questions you may have. King Canopy/PIC America, LTD. has no control over wind, snow, ice, rain or any other weather condition and we are in no way responsible for any damage caused by the canopy or to the canopy.
PAGE 9
PRODUCT INFORMATION Defective Parts We try our best to eliminate any defective parts that are shipped with our products. If, however, you should find a defective part, we will replace – free of charge – any part which is defective. You will need to provide proof of purchase showing date of purchase and provide us with detailed description of the defective component. Your replacement will be shipped by ground shipping, freight prepaid.