Owner Manual

COVER ASSEMBLY
Step 1
Unfold the cover with the grommets toward the cover’s bottom and place over the frame. The ared edges
should be located at each of the 4 corners of the frame.
Step 2
Begin attaching the cover with the elastic ball straps by inserting the elastic cord of the ball strap underneath
the cover and through the grommet. Then pull cord taut until ball stops. Wrap the cord around the pole and
under the ball. This will hide the ball under the cover and provide a more nished look to your unit.
• Start by attaching 2 elastic ball straps at each of the four corners
• Continue attaching straps from left to right in a zigzag pattern down both sides of the canopy
• Attach straps at the front and back of the unit, again using a zigzag pattern until all straps are secured
Note:
The ball straps are long enough to accommodate various cover lengths. If your straps need a tighter t, they
can be shortened by making an additional knot in the cord strap. Slide the ball upward to reveal the tied knot.
Tie a new knot above the old one. The size of the knot will determine how short the strap becomes.
Slip the ball down over the new knot and secure.
Inside View Outside View
Start at Corners
Go Left to Right
Go Front to Back
End Here