Manual

10
®
®
®
P
I
P
E
T
H
R
E
A
D
S
E
A
L
A
N
T
MATERIALS NEEDED
Pipe Thread
Sealant
Primer and
PVC Cement
OFF-LINE KIT
Included with the
New Water® Cycler
Two Male
Adapters
Two Reducer
Bushings
Two 90
Degree Elbows
Four Hose
Clamps
6’ of Tubing
Two
Scoops
Two Scoop
Gaskets
Two Scoop Clamps
RECOMMENDED
Corrosion Resistant
Check Valve
#10 x 1 1/4” Phillips
Pan Head Screws with
Washers
TOOLS NEEDED
Screwdriver
Pipe Wrench
Battery
Operated Drill
with 5/8” or 19/32”
Bit
In Ground, Off-line Installation - Model 430
Do NOT install an off-line Cycler
in-line as this Cycler is different
than an in-line unit.
1.
When insufficient room for an in-line application, install off-line in
straight pipe with scoops between 2” - 36” apart. Install as far
from the heater as possible.
Bi-flow valve design allows water flow in either direction.
Following Primer directions,
brush Primer on reducer
bushings and inside of male
adapters. Repeat this process
with PVC cement following
directions on that product.
Insert reducer bushing
into male adapter on both
sides with a twisting action.
Hold in place 5 to 10 seconds
to bond.
Following pipe thread sealant
directions, brush sealant onto
elbow threads.
2.
3. 4. 5.
OR
PVC
CEMENT
PVC
CEMENT
W
a
t
e
r
C
Y
C
L
E
R
M
e
t
e
r
e
d
P
o
o
l
P
u
r
i
f
i
e
r
Following pipe thread sealant
directions, brush sealant
onto New Water® Cycler
threads in both ports and on
both male adapters.
DO NOT USE PIPE THREAD
TAPE as the threads
on these units are
not suitable for
this use and
leaking or fitting
failure could result.
Screw a male adapter
into each port of New Water®
Cycler. Hand tighten. Finish
tightening by turning 1 to 2
revolutions with wrench.
DO NOT
OVER
TIGHTEN.
®
SCOOPS
2” – 36” APART
• Install after all
equipment and as far as
possible from heater.
• Any additional sanitizing
equipment that is installed
with New Water® Cycler must
be installed after New Water®
Cycler (never before) on the
return line to the pool.