Manual

7
TO POOL
PUMP
FILTER
®
®
TOOLS NEEDED
Screwdriver
Pipe Wrench
Materials Needed
Pipe Thread Tape
or Sealant
Two hose adapters
1 1/2” x 1 1/2” x 1 1/4”
Two Sections of 1 1/2”
Flex Hose (one provided
with filter)
Two
Hose
Clamps
Recommended
Corrosion Resistant
Check Valve
4-8 psi Back Pressure
To avoid over or under chlorination,
replace eye ball fittings in the return
jets to a smaller or larger size to
adjust back pressure.
10 x 1 1/4” Phillips
Pan Head Screws with
Washers
Apply pipe thread tape or
sealant to the threaded end of
both hose adapters.
1.
The New Water® Cycler should always be
installed between the filter and pool (or
between heater and pool if applicable).
Above Ground, Base Installation - Model 120
Screw adapters into each end of New
Water® Cycler. Hand tighten. Finish
tightening by turning 1 to 2 revolutions
with wrench. DO NOT OVER TIGHTEN.
2.
Attach the filter section of flex hose to one hose
adapter and the return section of flex hose to the other
hose adapter with clamps and tighten with screwdriver.
Bi-flow valve design allows water flow in either direction.
3.
Isolating the New Water® Cycler by installing a
corrosion resistant check valve is recommended.
4.
For better stability, the
New Water® Cycler may be
mounted on a base using
Phillips pan head screws.
One in front and two in
back.
5.
Option
1 1/2” Male Adapter
(slip x MPT)
or
2” Female Adapter
(slip x FPT)
When installing with hard
PVC pipe, use either a female
adapter on the outside port
threads or a male adapter on
the inside port threads.
®
HOSE
CLAMP
HOSE
ADAPTER
HOSE
CLAMP
HOSE
ADAPTER
TO POOL
1 1/2" OR 1 1/4"
FLEX HOSE
1 1/2" X 1 1/2" X 1 1/4"
HOSE ADAPTER
HOSE
CLAMP
FILTER &
PUMP
®
• Install after all equipment and
as far as possible from heater.
• Any additional sanitizing
equipment that is installed with New
Water® Cycler must be installed after
New Water® Cycler (never before) on
the return line to the pool.