User Manual

Use FROG
®
Brand Test Strips to accurately
maintain the reduced 1.0 to 2.0 ppm bromine
level following the label directions carefully.
• Begin regular spa care procedures
(see back page) as soon as start up is
complete.
Setting Cartridges
Set the blue mineral
cartridge to wide open on
#6 by holding the bottom
and turning the top until
the number 6 appears in
the setting window. No further
adjustments are necessary.
With a freshly filled spa, initially
set the yellow bromine cartridge on #5 for the
first 24 hours ONLY. Then the first week or
so, before each use, test the water and adjust
cartridge by 1 setting per day until the bromine
stabilizes to at least 1.0 ppm.
Spa Start Up
Always drain and refill spa at least every
4 months.
Clean and replace filter cartridges when
dirty (Follow manufacturer’s instructions).
Balance water according to the chart.
Heat water to
recommended
temperature
before using car-
tridges.
Very Important!
Before using cartridg-
es, establish an initial
residual of 1.0-2.0 ppm bromine or chlorine. Do not use a
non-chlorine shock.
*For best results use FROG
®
Jump Start
that quickly dissolves with an effervescent
fizzing action – one pack per 500 gallons.
Water Balance Guidelines
pH: 7.2 – 7.8
Total Alkalinity: 80 - 180 ppm
Calcium Hardness: 150-400
Total Dissolved Solids: <1500
Free Bromine: 1.0 - 2.0 ppm
Using the Floating System
Insert both car-
tridges into the
green floating holder
by pushing them into
the openings until
they stay in place.
Let the SPA FROG
®
Floating System free-
float in the spa.
When
using the
spa, simply
remove the
SPA FROG
®
System, drain
most of the water into the spa
and set on the side of the spa inverted so all
excess water drains into the holder.
• REMEMBER TO REPLACE IT IN THE
WATER WHEN FINISHED USING SPA!
Replacing Cartridges
The SPA FROG
®
Mineral Cartridge must be
replaced every 4 months. After four months
of use, or when draining and refilling the spa
with fresh water, discard SPA FROG
®
Mineral
Cartridge in trash even if, upon shaking, it
appears there is spent media left inside. Once
wetted the time released minerals in the car-
tridge are effective up to four months. Do not
attempt to reuse the product once removed
from the spa. For ease in remembering to
replace, mark your calendar with the reminder
stickers
provided with the product.
• Replace the SPA FROG
®
Bromine Cartridge
when empty. Drain water to ensure cartridge is
empty then discard in trash. The cartridge life will
vary depending on spa size and number of users.
Once your usage is determined, mark the calen-
dar with enclosed reminder stickers.
REPLACEABLE CARTRIDGES
REUSABLE HOLDER
Instalación de los cartuchos
Programe el cartucho azul de
minerales completamente abierto
en el N 6 sosteniendo la parte
inferior y girando la parte superior
hasta que aparezca el número 6 en
la ventana de programación. No se
necesitan ajustes adicionales.
En un spa que fue recién llenado, primero
programe el cartucho amarillo de bromo en el
N 5 para las primeras 24 horas SOLAMENTE.
Desps, durante la primera semana aproximada-
mente, antes de cada uso, controle el agua y ajuste
el cartucho de a una posición por día hasta que el
bromo se estabilice en por lo menos 1,0 ppm.
Puesta en marcha del spa
Siempre vae y vuelva a llenar el spa por lo
menos cada 4 meses.
Limpie o cambie los cartuchos del filtro cuando se
ensucien
(siga las instrucciones del fabricante).
Equilibre el agua de acuerdo a la tabla.
• Caliente
el agua a la
temperatura
recomendada
antes de usar
los cartuchos.
¡Muy importante!
Antes de usar los
cartuchos, establezca un nivel residual inicial de 1.0 a 2.0
ppm de bromo o cloro. No utilice un tratamiento de choque
sin cloro.
*Para obtener los mejores resultados,
utilice FROG
®
Jump Start, que se disuelve
pidamente con una acción efervescente;
un paquete por cada 500 galones
(1,892.5 litros).
PAUTAS PARA EL EQUILIBRIO DEL AGUA
pH: 7,2 – 7,8
Alcalinidad Total: 80 -180 ppm
Dureza del calcio: 150-400
Total de sólidos disueltos: <1500
Bromo libre: 1,0 -2,0 ppm
mo usar el SPA FROG
®
Floating System
• Introduzca ambos
cartuchos en el
sujetador flotante
verde empujándolos
hacia las aberturas
hasta que queden fijos.
• Deje que el SPA FROG
®
Floating
System flote
libremente en
el spa.
• Cuando use el spa,
simplemente saque el SPA
FROG
®
Floating System vierta la mayor parte
del agua dentro del spa y colóquelo invertido
a un costado del spa para que todo el exceso
de agua vaya al sujetador.
• ¡RECUERDE VOLVER A COLOCARLO EN
EL AGUA CUANDO DEJE SE USAR EL SPA!
Cómo cambiar los cartuchos
Debe cambiar el SPA FROG
®
Mineral Cartridge
cada 4 meses. Después de cuatro meses de
uso, o cuando vacíe y vuelva a llenar el spa con
agua nueva, deseche el SPA FROG
®
Mineral
Cartridge aún cuando, después de agitarlo,
pareciera que todavía quedaran sustancias en
el interior. Una vez que los minerales de lib-
eración gradual del cartucho se mojan, éstos
tienen efecto hasta cuatro meses. No intente
volver a usar el producto una vez que lo
saque del spa. Para acordarse fácilmente de
reemplazarlo, marque su calendario con los adhe-
sivos recordatorios que vienen con el producto.
• Cambie el SPA FROG
®
Bromine Cartridge cuan-
do esté vacío. Vierta el agua para asegurarse
de que esté vació y deséchelo. La duración del
cartucho dependerá de la medida del spa y de
la cantidad de usuarios. Una vez que determine
su uso, marque el calendario con los
adhesivos
recordatorios que se adjuntan.
CARTUCHOS REEMPLAZABLES
SUJETADOR REUTILIZABLE
NOTE: Bromine levels are lower only
when used with FROG minerals
NOTA: los niveles de bromo son menores
solo cuando éste se utiliza con los minera-
les FROG.
®
B R AN D
Utilice las tiras de prueba FROG
®
Test Strips ara
mantener con exactitud el nivel reducido de 1.0
a 2.0 ppm de bromo, siguiendo atentamente las
instrucciones en la etiqueta.
• Comience con los procedimientos para
el cuidado habitual del spa (vea la contraportada)
tras finalizar la puesta en marcha.
®
B R AN D
SETTING
WINDOW
®
BRAND
VENTANA DE
PROGRAMACIÓN
®
BRAND
20-48-0157 Floating system.indd 2 10/20/11 2:10 PM