Datasheet

SPEC NO: DSAD1550 REV NO: V.9 DATE: SEP/04/2007 PAGE: 6 OF 9
APPROVED: WYNEC CHECKED: Tracy Deng DRAWN: W.J.ZHU ERP: 1205000014
PHOTOCOUPLER
Part Number: KB827
Fig. 11 Collector-emitter Saturation
Voltage vs. Forward Current
*NOTES ON HANDLING
1.Recommended soldering conditions (Dip soldering)
(1) Dip soldering
Temperature 260 °C or below (molten solder temperature)
Time Less than 10 seconds.
Cycle One cycle allowed to be dipped in solder including plastic mold portion.
Flux Rosin flux containing small amount of chorine
(The flux with a maximum chlorine content of 0.2 Wt % is recommended.)
(2) Cautions
Fluxes
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
2.Cautions regarding noise
Be aware that power is suddenly into the componment any surge current may cause damage happen,
even if the voltage is within the absolute maximum ratings.