User Manual

Document No. 480ADT2000.A00
DT2000
Page 11 of 17
12. How to reset the DT2000
If you forget the User PIN or want to delete all data stored on the DT2000, follow the
instructions below.
The reset process will clear all cryptographic parameters, including the User PIN. This means
that the DT2000 will revert to the default User PIN of 11223344 - see section 4 on page 6 on
how to change the User PIN. Also, since this will force the creation of a new encryption key, the
DT2000 will have to be reformatted (see section 13 or 14).
Caution: Resetting the DT2000 will delete all data stored on the drive.
Instructions
LED
LED Status
1. Press and hold down the number 7 (pqrs) button and then
press the KEY button. Release buttons (7 & )
Red and Green LEDs blink
alternately
2. Within 10 seconds, press the number 9 (wxyz) button three
times (triple-click) (999)
Red and Green LEDs continue to
blink alternately
3. Press and hold down number 7 (pqrs) button and then Press
the KEY button. Release buttons (7 & )
Red LED fades out to complete the
reset process