User Manual

Document No. 480ADT2000.A00
DT2000
Page 4 of 17
Introduction
Thank you for purchasing the DataTraveler
®
2000, an ultra-secure and easy-to-use hardware-
encrypted USB 3.0 PIN-activated flash drive.
The DT2000 uses military-grade XTS-AES 256-bit hardware encryption, which encrypts all data
stored on the drive in real time. The DT2000 requires no software and is OS and host
independent.
The DT2000 incorporates a rechargeable battery that allows you to enter a 7-15 digit PIN
(Personal Identification Number) using the on-board keypad before connecting the drive to
a USB port.
Should the drive be lost or stolen, you can rest assured that all data held on the DT2000 is safe
and cannot be accessed by any unauthorised person.
The DT2000 unlocks using the on-board keypad and is not unlocked by a host computer. It is
not vulnerable to software/hardware-based key loggers or brute force attacks.
Note: The DT2000 rechargeable battery is not fully charged out of the box. We
recommend that you charge the battery prior to first use. To charge, plug the
DT2000 in to a powered USB port for 60 minutes to fully charge the battery.
Caution: The DT2000 is shipped with a default PIN of User PIN of 1-1-2-2-3-3-4-4
and, although it can be used straight out of the box with the default
PIN, for security reasons we highly recommend that you create a new
User PIN immediately by following the instructions under section 4 ‘How to
change User PIN’.
If you forget your PIN, all data will be inaccessible.