Ventilation Pairing Guide

UNDER CABINET HOODS
30” - KVUB400GSS
36” - KVUB406GSS
30” - KVUB600DSS
36” - KVUB606DSS
30” - KXU2830JSS
36” - KXU2836JSS
KFGG500E KSGB900E KFGD500E YKSDB900ESS KFDD500ESS KSGG700E KSDG950ESS
GAS FREESTANDING RANGES AND VENTILATION PAIRING GUIDE
WALL MOUNT AND
ISLAND MOUNT HOODS
30” - KVWB400DSS
36” - KVWB406DSS
30” - KVWB600HBS
36” - KVWB606HBS
36” - KVIB606DSS
PRO STYLE VENTILATION
AND LINERS
30” - KVUC600JSS
36” - KVUC606JSS
36” - KVWC906JSS
48” - KVWC908JSS
36” - KVWC956JSS
48” - KVWC958JSS
30” - UVL5430JSS
36” - UVL6036JSS*
48” - UVL6048JSS*
30” REAR CONTROL 30” FRONT CONTROL
GAS FREESTANDING RANGES
* Custom hood liners can be used with any of the following blower motors:
UXB1200DYS (1,170 CFM), UXI1200DYS (1,200 CFM), UXB0600DYS (585 CFM)
** Motor Class CFM rating
Observe all governing codes and ordinances. Have a qualified technician install the range hood. It is the installer’s responsibility to comply with
installation clearances specified on the model/serial/rating plate. The model/serial/ rating plate is located inside the range hood on the rear wall
of the range hood. Canopy range hood location should be away from strong draft areas, such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance. The canopy range hood is factory
set for venting through the roof or through the wall. All openings in ceiling and wall where canopy range hood will be installed must be sealed.
IMPORTANT: Dimensional specifications are provided for planning purposes only. Do not make any cutouts based on this information.
Refer to installation instructions packaged with product before selecting cabinetry, making cutouts or beginning installation.