Installation Instructions

10 SINGLE MODELS ONLY
Check the position of the chassis is still where marked on the
cavity, before securing the product.
11 There are four 16mm round holes, two on the left and two on the
right hand side in the sound insulation. These provide access to
the mounting tabs.
To secure the product to the cabinetry use a 16mm Phillips screw
in each mounting tab.
Make sure the sound insulation is positioned correctly before
continuing installation.
12 Screw the two top tabs to the underside of bench. Use the
supplied Phillips 16mm screws. Tabs can accommodate a
maximum of 19mm vertical gap.
Step 4: securing the product
10
11
12
17
Important!
Before refitting the tub, ensure the hoses are not twisted and
the latches at the rear of each drawer runner are facing
forward.
13 To refit the tub, make sure both of the latches at the rear of each
drawer runner are facing forward. Ensure hoses are hooping
upward. Place the tub on the half open drawer runners and close
the drawer.
14 Check the tub clips have reset on both sides of the tub. If not, pull
the tub clips forward until the tub clip button is reset.
Important!
Ensure the tub clips on both sides are reset.
Step 5: refitting the tub
13
14
Latch
Drawer
Runner
Latch
Bracket
TUB CLIP
INCORRECT
5019_102_00273_INSTAL_GB 30-05-2007 13:25 Pagina 17