Installation Instructions

WARNING!
DO NOT plug the product in at this stage.
Important!
DO NOT cut the inlet hose.
17 Connect the Inlet Hose to the water supply. Ensure the sealing
washer is in place. The hose coupling must be tightened a further
half turn after seal contact. TIP - Turn the water valve ON to
check for any leaks.
18 Ensure there is a power outlet in reach of the power supply cord.
If there is not a suitable outlet available then have one installed by
a qualified electrician.
NOTE: SINGLE MODELS DO NOT HAVE A TOE KICK TO INSTALL.
PROCEED TO STEP 11 FINAL CHECK LIST.
Step 7: connecting the inlet hose and power supply
18
17
VALVE
WATER
SUPPLY
200mm
MINIMUM
BENDS RADIUS
FROM VALVE
POWER
OUTLET
WASTE
WENT
19
19 Partially open the bottom drawer. Turn Prefinished Toe Kick
upside down and hold vertically against the bottom edge of the
Tub side (not the drawer front).
Mark the position of the bottom edge of the Tub side on the Toe
Kick.
Choose the nearest groove to the pencil mark which will result in
the shortest Toe Kick.
Step 8: measuring the toe kick
19
Botton edge
of tub side
5019_102_00273_INSTAL_GB 30-05-2007 13:25 Pagina 19