Quick Start Manual

17
Level Range
NOTE: Range must be level for satisfactory baking performance.
1. Place rack in oven.
2. Place level on rack and check levelness of the range, first
side to side; then front to back.
3. If range is not level, adjust the leveling rods. Turn leveling
rods located behind the kick plate to level range and to raise
or lower range to the desired countertop height.
NOTE: All roller feet must be off the floor upon final installation.
Install Grill Grease Trays
(on grill models)
1. Remove flame spreader. Pull forward slightly on the flame
spreader to release the tabs from the rear slots and lift out.
2. Cut and remove tie strap from rear of burner assembly.
3. Lift burner assembly up and out to remove.
4. Slide drip tray into opening on the right front side of the grill
basin. There are guides to assure correct placement of the
drip tray.
5. Insert the large grease tray all the way under the back edge of
the grill basin and hook it into the slots.
6. Insert the small grease tray all the way under the front of the
grill basin and hook it into the slots.
When the 2 grease trays are installed properly, the small
grease tray will hook over the large grease tray.
A. Front leveling rod
B. Rear leveling rod
A. Grill front
B. Rear tabs and slots
A
A
B
B
A
B
A. Tie strap
A. Drip tray
A. Large grease tray
B. Slots
A. Large grease tray
B. Grease tray connection
C. Small grease tray
D. Slots
A
A
A
B
A
B
C
D