Assembly Instructions

DISHWASHER FEEDBACK
CONTROL PURPOSE COMMENTS
START
Press to start or resume a wash
cycle.
If the door is opened during a cycle or power is interrupted,
Start/Resume indicator light ashes. Cycle will not resume until
door is closed and Start/Resume is pressed.
NOTE: Push door rmly closed within 4 seconds of pressing
Start/Resume. If door is not closed within 4 seconds, the Start/
Resume button light will ash, an audible tone will be heard,
and cycle will not start.
CANCEL Press to cancel wash cycle.
Close door rmly. The dishwasher starts a 2 minutes drain (if
needed). Let dishwasher drain completely.
CONTROL
LOCK
Control Lock avoids unintended
use of dishwasher between cycles
or cycle and option changes
during a cycle.
To turn on Lock, press and hold heated dry for 3 seconds.
Control Lock light will stay on, indicating that it is activated and
all buttons are disabled. If you press any button while your
dishwasher is locked, light ashes 3 times. Dishwasher door
can still be opened/closed while controls are locked.
To turn o󰀨 Lock, press and hold heated dry for 3 seconds. Light
turns o󰀨.
Cancelling a Cycle
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop before completely opening the door.
2. Press and hold START/RESUME for 4 seconds. The Cancel/
Drain light will turn on.
3. Close the door, and the dishwasher starts a drain cycle (if
water remains in bottom of dishwasher). Let the
dishwasher drain completely. The Cancel/Drain light turns o󰀨
after 3 minutes.
Changing a Cycle After Dishwasher Is Started
You can interrupt a cycle and restart the dishwasher from the
beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is
open, you will need to rell the detergent dispenser before
restarting the new cycle.
3. Press CANCEL/DRAIN to reset the control.
4. Select new cycles and options.
5. Press START/RESUME.
Adding a Dish After Dishwasher is Started
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop, then open the door completely.
2. Check whether the detergent dispenser cover is still closed.
If it is open, the wash cycle has already started and adding a
dish is not recommended.
3. If detergent has not yet been used (detergent dispenser
cover is closed), you may add a dish.
4. Push door rmly closed and press START/RESUME within 4
seconds. If you take too long, the Start keypad light ashes,
and you will hear an audible tone. Press START/RESUME
again and close the door within 4 seconds.