Installation Instruction

12
3. If the oven bake ame needs to be adjusted, locate the
air shutter near the center rear of the range. Loosen the
locking screw and rotate the air shutter until the proper ame
appears. Tighten locking screw.
A
B
4. Press CANCEL/OFF when nished.
5. Reinstall ame spreader and oven bake burner cover.
Check Operation of Oven Broil Burner
1. Close the oven door.
2. Press the BROIL pad.
3. Press the START pad.
The oven burner should light within 8 seconds. Under certain
conditions, it may take the burner up to 50 to 60 seconds to
light.
Refer to the Use and Care Guide or User Instructions for proper
operation of the oven controls.
Adjust Oven Broil Burner Flame (if needed)
Look through oven window to check broil burner for proper
ame. This ame should have a 1/2" (1.3 cm) long inner cone of
bluish-green, with an outer mantle of dark blue, and should be
clean and soft in character. No yellow tips, blowing or lifting of
ame should be present.
If Flame Needs To Be Adjusted:
1. Loosen the lock screw on the air shutter located at the rear
of the broil burner.
2. Adjust the air shutter as needed.
3. Tighten lock screw.
4. Press CANCEL/OFF when nished.
A
B
A. Lock screw
B. Air shutterr
Warming Drawer or Premium
Storage Drawer
(on some models)
Remove all items from inside the warming drawer or premium
storage drawer, and allow the range to cool completely before
attempting to remove the drawer.
To Remove:
1. Open the warming drawer or premium storage drawer to its
fully open position.
2. Using a at-blade screwdriver, gently loosen the warming
drawer or premium storage drawer from the glide alignment
notch and lift up the drawer alignment tab from the glide.
A
B
C
3. Repeat Step 2 on the other side. The warming drawer or
premium storage drawer is no longer attached to the drawer
glides. Using both hands, pick up the warming drawer or
premium storage drawer to complete the removal.
To Replace:
1. Align the forward drawer notches with the notches in the
drawer glides on both sides. Place the rear alignment tabs
into the drawer glides on both sides.
A
B
2. Push the warming drawer or premium storage drawer in all
the way.
3. Gently open and close the warming drawer or premium
storage drawer to ensure it is seated properly on the glides
on both sides.
A. Locking screw
B. Air shutter
A. Flat-blade screwdriver
B. Drawer alignment tab
C. Drawer glide notch
A. Drawer alignment tab
B. Drawer glide notch