Installation Instructions

Install Trim Kit Frame

1. Position trim kit frame over the opening so that the upper tabs

fit inside the rails, as shown.

2. To vertically center the trim kit frame, slide it upward, against

the opening, until the upper tabs catch against the top of the

rails.

3. Holding the trim kit frame firmly in place, use 7/64" drill to drill

four pilot holes into the front facing of the cutout/cabinet

through the mounting hole guides in the upper and lower

corners of the trim kit frame.

NOTES:

■ To ensure vertical centering, drill the lower holes first.

■ The holes will be drilled upward from the bottom, and

downward from the top at an angle of about 45°.

4. Secure trim kit frame to cutout/cabinet by installing four long

wood screws (painted) into the pilot holes drilled in Step 3

above.

NOTES:

■ To ensure vertical centering, install the lower screws first.

■ To avoid damage to the trim kit frame, do not overtighten

screws.

Installation is now complete. Replace any loose items that have

been removed from microwave oven cavity.

Save these Installation Instructions for future reference.

A. Front of trim kit frame

B. Upper tab

C. Rail

D. Lower tab

A. Trim kit frame

B. Upper tab

C. Rail

D. Cutout floor

E. Long wood screw (4 - painted)

F. Mounting hole guide