Owner's Manual
Table Of Contents
- REFRIGERATOR SAFETY
- Refrigerator Safety
- REFRIGERATOR CARE
- Cleaning
- Changing the LED Module
- Refrigerator Shelves
- Opening and Closing Doors
- Vacation and Moving Care
- INSTALLATION INSTRUCTIONS
- Unpack the Refrigerator
- Location Requirements
- Electrical Requirements
- Water Supply Requirements
- Connect the Water Supply
- Complete the Installation
- Install Air Filter (on some models)
- Install Produce Preserver (on some models)
- REFRIGERATOR FEATURES
- Crisper Humidity Control (on some models)
- Water and Ice Dispensers (on some models)
- Ice Maker and Storage Bin
- Water Filtration System
- DOOR AND HANDLE INSTRUCTIONS
- Door and Drawers
- Remove and Replace Handles
- Remove Refrigerator Doors and Hinges
- Reset Bottom Refrigerator Door Hinge
- Replace Refrigerator Doors and Hinges
- Remove and Replace Refrigerator Drawer
- Door Closing and Alignment
- PERFORMANCE DATA SHEET
- Performance Data Sheet
- SÉCURITÉ DU RÉFRIGÉRATEUR
- Sécurité du réfrigérateur
- ENTRETIEN DU RÉFRIGÉRATEUR
- Nettoyage
- Remplacer le module à DEL
- Tablettes du réfrigérateur
- Ouverture et fermeture des portes
- Précautions à prendre avant les vacances ou le déménagement
- INSTRUCTIONS D’INSTALLATION
- Déballage du réfrigérateur
- Exigences d’emplacement
- Spécifications électriques
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- Terminer l’installation
- Installer le filtre à air (sur certains modèles)
- Installation du conservateur de produits frais (sur certains modèles)
- CARACTÉRISTIQUES DU RÉFRIGÉRATEUR
- Commande d’humidité dans le bac à légumes (sur certains modèles)
- Distributeur d’eau et de glaçons (sur certains modèles)
- Machine à glaçons et bac d’entreposage
- Système de filtration de l’eau
- INSTRUCTIONS POUR LA PORTE ET LA POIGNÉE
- Porte et tiroirs
- Pour enlever et réinstaller les poignées
- Démontage des portes et charnières du réfrigérateur
- Réinitialiser la charnière inférieure du réfrigérateur
- Réinstallation des portes et charnières
- Retrait et réinstallation du tiroir de congélation
- Fermeture et alignement des portes
- FICHE DE DONNÉES DE PERFORMANCE
- Fiche de données de performance
23
1. Open the drawer to its full extension, and remove the interior
bin.
2. Left-hand drawer only: Remove the wiring connection cover.
Press in on the side of the cover to release the tab from the
slot, and then pull the cover away from the bracket.
A. Cover tab B. Wiring connection cover
3. Left–hand drawer only, disconnect the wiring.
NOTE:
� On one side of the wiring connector, insert the screwdriver
blade between the connector tab and the connector to
release. Repeat for the opposite side. Pull the wiring
connector apart.
4. Remove the drawer front.
Style 1: Bottom Release Lever
� Push up on the lever at the bottom of the drawer glide
bracket to release the drawer front from the bracket.
� Lift the drawer front up and off the drawer glide brackets.
A. Drawer glide bracket B. Release lever
Style 2: Bottom Screws
� Loosen the two top screws attaching the drawer glide
brackets to the drawer front.
NOTE: Loosen screws three to four turns. Keep the
screws in the drawer front.
� Remove the two bottom screws attaching the drawer glide.
� Lift the drawer front up and off the top screws.
A. Four Bracket screws
5. Slide the drawer glides back into the refrigerator.
REPLACE DRAWER FRONT
1. Pull out the drawer glides until they are full extended.
2. Style 1: Bottom Release Lever
� Push up on the lever at the bottom of the drawer glide
bracket to open. Insert the drawer front bracket into the
drawer glide bracket and release the lever.
Style 2: Bottom Screws
� Lower the loosened screws in the top of the door front into
the upper notches in the drawer glide.
� Align the holes in the bottom of the drawer glides.
� Replace two screws removed previously and tighten all
four screws.
NOTE: It helps if one person holds the drawer glides steady
while another person aligns the drawer front and inserts the
screws into the notches.