Owners Manual

7
Cabinet Dimension
Interior-mounted blower motor model
NOTES:
■ See cooktop manufacturer’s instructions for cooktop cutout
depth and width.
■ Use dimensions for vent system cutout location that applies
to your installation.
■ Interior-mounted blower systems connect with 3
1
/
4
" x 10"
(8.3 cm x 25.4 cm) rectangular or 6" (15.2 cm) round vent
system. The cutout locations for this vent system will depend
on your specic installation.
Exterior-mounted blower motor model
NOTES:
■ See cooktop manufacturer’s instructions for cooktop cutout
depth and width.
■ Exterior-mounted blower systems connect with 10" (25.4cm)
round vent. The cutout locations for this vent system will
depend upon your specic installation.
Countertop Cutout Dimensions
IMPORTANT: Countertops with a bull-nosed front edge are not recommended for these installations.
Some models require a countertop deeper than 25" (63.5 cm); see the following illustrations.
To avoid mistakes, it is recommended that the cooktop and vent cutouts be drawn on the countertop before making any cutouts.
See the Cooktop Installation Instructions for complete cutout dimensions, location dimensions, and installation details.
A = 1/2" (1.3 cm)
minimum
21⁵⁄₁₆"
(54.1 cm)
Cutouts are
for 3¹⁄₄" x 10"
(8.3 cm x 25.4 cm)
rectangular or 6"
(15.2 cm) round
vent system.
Centerline of cooktop cutout
21⁵⁄₁₆"
(54.1 cm)
Locate power
supply junction
box at lower
left-hand
rear corner
of the cabinet.
10" (25.4 cm)
1/2" (1.3 cm)
minim
um
Locate power
supply junction
box at lower
left-hand
rear corner
of the cabinet.
A
B
C
E
H
D
I
G
F
A. Downdraft vent
B. Cooktop
C. Measurement of cooktop rear overhang
D. Measurement of cooktop rear overhang
(C) + 1
13
/
16
" (4.6 cm) (E)
E. 1
13
/
16
" (4.6 cm)
F. 1/2" (1.3 cm) minimum
G. 1/4" (6.4 mm) minimum
H. Countertop and backsplash
I. 1/2" (1.3 cm) minimum