Assembly Instructions

4
If you choose, install a 1x4 or 2x4 ledger board
onto the wall at the bottom of your wall cabinet
height. This will give you a ledge to set your
wall cabinets on when installing and can assist
in keeping them level. This method requires
you to screw into your wall and could require
hole patching.
Usingastudnder,markoutallofthewallstudsthatwillbebehind
yourcabinets.
3)
Verifythatwallsaresquareandlevel.Wallsthatareoutofsquareor
levelwillmakeinstallationofcabinetsmoredicult.
Snapachalklineordrawalevellineat34-3/4"fromthehighest
pointofyouroor.Yourbasecabinetswillbeadjusteduptothatline
(topofbasecabinetwithoutcountertop).Snapanotherchalklineor
drawalevellineatto84-3/4"or94-3/4"(dependingifyouhave30"
or40"highwallcabinets).Yourwallandtallcabinetswillbeadjusted
up to that line. It may be helpful to draw out
your cabinet layout on the wall. This will give
you a guide to follow as you go.
1)
2)
CABINET INSTALLATION
Checktheoorforlevelandmakenoteofthe
highestpointsarebeforeinstallingcabinets.