SDS

KLEEN KOTE™ SDS
EFFECTIVE DATE: JANUARY 1, 2015
Page 3 of 6
Spill / Leak Procedures: Spill area will be slick. Stop spill at source if possible. Eliminate sources of ignition. Prevent entry into
sewers and waterways. Contain spill. Ventilate area if spilled in a confined space or other poorly
ventilated areas. Residual liquid can be absorbed by inert material. Recover all possible material for
reclamation. Dispose of in accordance with all Federal, State and Local environmental regulations.
Spill to Navigable Waters: If this material is spilled into navigable waters and creates a visible sheen, it is reportable to the
National Response Center at (USA) 800.424.8802.
SECTION 7. HANDLING AND STORAGE
Work/Hygienic Practices: Wash hands with soap and water before eating, drinking, smoking or use of toilet facilities. Do
not use gasoline, solvents, kerosene or other harsh or abrasive skin cleaners for washing exposed
skin areas. Take a shower after use if general contact occurs. Wash thoroughly after handling.
Launder articles before reuse and discard saturated articles that cannot be cleaned thoroughly.
General Handling Procedures: Wear water/oil resistant gloves and protective clothing. (Nitrile or Neoprene). Wear chemical
goggles with side shields. Keep containers closed when not in use. Keep away from flames,
sparks or hot surfaces. Never use a torch to cut or weld on or near containers. Empty containers
contain product residue which may exhibit hazards of the product. Maximum handling
temperature has not been determined.
Storage Procedures: Do NOT store near potential sources of ignition. Rotate stock. Store in clean, dry containers at
ambient temperatures and it should remain stable unless it is contaminated. Do NOT store at
temperatures great than 120⁰F (49⁰C). Maximum storage temperature has not been determined.
NFPA Class III-B storage.
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Ventilation Procedures: Use with adequate ventilation to control vapor concentrations.
Skin Protection: As needed to prevent repeated skin contact. Oil-resistant gloves should be used if
needed. Wash hands thoroughly after handling. Long sleeve shirt is recommended. Use
chemically protective boots when necessary to avoid contaminating shoes. Do NOT
wear rings, watches or similar apparel that could entrap the material and cause skin
irritation.
Eye Protection: Wear safety glasses with side shields or full face shield as needed.
Respiratory Protection: Not normally needed. Use NIOSH/MSHA approved respirator with a dust mist cartridge
if the recommended exposure limit is exceeded.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance Amber viscous liquid at room temperature
Upper/lower flammability None Known
or explosive limits:
Odor: Mild
Vapor pressure: Not Determined
Odor threshold: Not Determined
Vapor density (Air=1): >5
pH: Not Determined