Installation Guide

Guía de cinta pasadora
Amorce de ruban de tirage
Fish Tape Leader
Use with 1/8" wide
steel fi sh tapes
Utilícela con cintas
pasadoras de acero
anchas de 1/8 de pulgada
Utiliser avec des rubans
de tirage en acier de 1/8
po de large
ADVERTENCIAS: Utilice
siempre protección de los
ojos aprobada.
ADVERTENCIAS: No use
nunca la herramienta en circuitos
eléctricos con corriente ni cerca
de los mismos.
ADVERTENCIAS
WARNING: Always wear
approved eye protection.
WARNINGS
WARNING: Never use on or
near live electrical circuits.
AVERTISSEMENTS: Toujours
porter un dispositif de protection
des yeux homologué.
AVERTISSEMENTS: Ne
jamais utiliser sur des circuits
électriques sous tension,
ou à proximité de ceux-ci.
AVERTISSEMENTS
1. Make a clean cut of 1/8" steel tape where Leader will
be attached.
2. Separate Leader and Twist Cap. Slide Twist Cap onto
to tape as shown.
3. Heat tape to dull red and completely bend tip over 3/16"
using pliers. Allow tape to fully cool.
4. Slide Twist Cap to the end of the tape (over the bend)
and reconnect tightly onto Leader.
ENGLISH