Installation Guide

Parts Included
A. (2) Shelves
B. (1) Telescopic Post
C. (2) Universal Mounting Plates
D. (2) Bearing Hubs
E. (2) Bearing Pins
F. (8) #8 x 1/2” screws
G. (1) Installation Template
Tools Required
• Phillips head Screwdriver
• Drill with 1/16” (1.5mm) bit for
drilling pilot holes
• Tape measure or ruler
• Pencil
Product Assemblies
PFN20 PFN24
PFN28 PFN32
POLYMER FULL-ROUND LAZY SUSANS
Installation Instructions
RN-205-1EFS/0807
Inspect all parts and read all instructions prior to
beginning assembly and installation.
Use installation template to mark and drill 1/16˝ pilot
holes for universal mounting plates in top and bottom
interior of cabinet.
Fasten each of the universal mounting plates with (2)
#8 x 1/2˝ screws using the slots so that future
adjustment can be made, if necessary.
Insert bearing hubs into the underside of each of the
shelves. Note that the keyway on the side of the
bearing hub must be aligned with the key on the inside
of the shelf.
Slide the shelves onto the lower portion of the
telescopic post from the bottom (slotted side).
Place the assembly into the cabinet. Align the bottom
of the telescopic post over the top of the bottom
universal mounting plate making sure that the slot in
the post fits over the lug in the mounting plate. Push a
bearing pin through the slot in the pole and the hole in
the mounting plate. Slide the bottom shelf down onto
the pin.
Loosen the set screw that holds the upper portion of
the telescopic post enough to allow the upper portion
to move. Slide the upper portion up onto the top
universal mounting plate so that it is engaged securely.
Tighten the set screw to hold the upper and lower
portions of the post together securely.
Insert second bearing pin into one of the post’s upper
holes to give desired shelf separation. Slide top shelf
down over it. Your installation is complete!
2
3
4
5
1
step 8
6
7
2
3
4
5
1
6 7
C. (2) Universal
Mounting Plates
B. Telescopic Post
A. (2) Shelves
D. (2) Bearing Hubs
E. (2) Bearing Pins
F. (8) #8 x 1/2˝
Screws
Set Screw
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • www.kv.com
©2007 Knape & Vogt. All rights reserved. Knape & Vogt
®
reserves
the right to change specifi cations without notice.
Made in USA.