Installation Guide

Parts Included

A. Waste Bins (4)

B. Sliding Assembly

C. Mounting Screws (4)

4-BIN RECYCLING CENTER

Installation Instructions

310167-D_0615

Inspect all parts and read all instructions prior to beginning assembly

and installation.

2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA

800.253.1561 • 616.459.3311 • www.kv.com

Knape & Vogt

reserves the right to change speciﬁcations without notice. Made in USA.

Place sliding base assembly on cabinet floor, centered behind the back edge of the cabinet face

frame. If installing in a frameless cabinet , measure 3/4" back from front of cabinet opening, and

align sliding base assembly parallel to cabinet opening. Close door to make sure the assembly will

not hold cabinet door open. Also, check to see if unit will clear the door opening when fully extended.

Once position is determined, fasten in place using four mounting screws provided and the Phillips

head screwdriver.

Optional Step

Mark placement of mounting holes with a pencil, remove sliding base assembly and drill pilot holes

for fastening screws. Place sliding base assembly back into position and fasten with the provided

screws.

Insert bin(s) into wire support frame to complete the installation.

Top View

BSC24-4-27

Overall

Cabinet Width:

24"

BIN

Tools Required

• Phillips screwdriver

• Tape Measure

• Pencil

• Drill with 1/16˝ bit for pilot holes (optional)

Product Assemblies

SCB24-4-27 SBM24-4-27