Installation Guide

Place sliding assembly on cabinet floor, right behind the back edge of the cabinet face frame. If

installing in a frameless cabinet, measure 1/2" to 3/4" back from front of cabinet opening, and

align sliding base assembly parallel to cabinet opening. Close door to make sure the assembly will not

hold cabinet door open. Also, check to see if unit will clear the door opening when fully extended.

Once position is determined, fasten in place using four mounting screws provided and the Phillips

head screwdriver.

Optional step: Mark placement of mounting holes with a pencil, remove sliding base assembly and

drill pilot holes for fastening screws. Place sliding base assembly back into position and fasten with

the provided screws.

Insert bins into cages. Place lids on top of bins (if supplied). The orientation of your bins is

demonstrated in the Top View chart below. If your unit does not come pre-packed with lids and you

would like lids, visit www.kv.com to purchase the lids you require. Installation is now complete.

Parts Included

A. Waste Bin(s) (3)

B. Sliding Assembly

C. Mounting Screws (4)

D. Lids (if supplied)

SLIDING TRIPLE WASTE BINS

Inspect all parts and read all instructions prior to beginning assembly and installation.

310173-D_0615

Top View

Triple Bin

BIN

Overall Cabinet Width:

18”

BIN

Tools Required

• Phillips Screwdriver

• Tape Measure

• Pencil

Optional

• Drill with 1/16" bit for Pilot Holes

Product Assemblies

SCB-15-3-20 SBM-15-3-20

2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA

800.253.1561 • 616.459.3311 • www.kv.com

Knape & Vogt

reserves the right to change speciﬁcations without notice. Made in USA.