Use and Care Guide

9
OPERATING INSTRUCTIONS
3. LED Worklight
The LED worklight (C), located on the front of the
saw, will illuminate when the variable-speed trigger
switch (E) is depressed. This provides additional
light on the surface of the workpiece for operation in
lower-light
conditions. The LED worklight will turn off
when the trigger switch is released.
4. Orbital-Function Lever
This reciprocating saw has the option of orbital
action to make the blade swing slightly as it cuts.
a. Disconnect the saw from the power supply.
b. Turn the orbital-function lever (D) to the “
”
position for orbital cutting action.
c. Turn the orbital-function lever to the “
” for
straight cuts without orbital action.
Orbital action increases the speed of the cut, but
may result in a rougher nish to the cut in some
materials. Experiment on a piece of scrap material
in order to determine the optimum pendulum action
setting. Do not turn the lever during cutting to
prevent accidental injury.
3
C
4
D