Use and Care Guide

PREPARATION / PRE-ASSEMBLY INSTRUCTIONS

AIR SUPPLY SET-UP

Before beginning assembly or operation of product, make sure all parts are present.

Compare parts with package contents list. If any part is missing or damaged, do not

attempt to assemble the product.

Estimated Assembly Time: 3 minutes.

NOTE: The life of this product and the efficiency of its operation depends upon the

knowledge of its construction, usage and maintenance. Not all accessories shown

are included, but recommended for best performance (See Figure 1).

WARNING: TO PREVENT SERIOUS INJURY FROM EXPLOSION:

Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen,

carbon dioxide, combustible gases, or any other bottled gas as a power source for

this tool.

WARNING: TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Do not install a female coupler directly onto the tool. This type of coupler will allow

the air tool to retain pressure and operate accidently after the air supply is

disconnected.

WARNING: Lubricators should not be used with spray guns, the use of inline

lubricators will contaminate the material and will ruin the paint finish.

Recommended Air Line Set-Up

DPART NO. escription

VLP Spray Gun

Air Pressure Regulator

Female Plug (not included)

Female Coupler (not included)

Air Hose (not included)

In-Line Filter (not included)

Air Compressor (not included)

3 4 5 3 4

6 7

Air Supply Set-up

1. It is recommended that an in-line air filter be incorporated into the air supply.