Use and Care Guide

CARE AND MAINTENANCE

2. Screw the Fluid Nozzle (B) into the face of the

spray gun by turning it clockwise, using the

wrench (J) (13 mm) to tighten securely

(See Figure 3).

3. Screw the Air Cap Ring (A) onto the face of the

spray gun by turning it clockwise and hand

tighten. (See Figure 4)

4. Slide the Paint Needle through the back of the

Spray Gun. (See Figure 5-6)

Clockwise

NOTE: Make sure the hole in the trigger is

properly aligned or the paint needle cannot be

inserted.

RE-ASSEMBLING SPRAY GUN

1. The Air Distribution Ring can only be inserted

correctly one way (See Figure 1 and 2)

NOTE: The line on the Air Distribution Ring

(Figure 2) must be lined up to the hole shown

in Figure 1.