Use and Care Guide

OPERATING INSTRUCTIONS

4. Pre-mixed cement mix instructions

Note: Refer to instructions from the pre-mix cement mix manufacturer.

CARE AND MAINTENANCE

AFTER USE: Clean out the drum with water. If cement has dried to the inside of mixer, tap the

outside of the drum with a rubber or plastic mallet. Dump mixer to empty dried cement from drum

(DO NOT use a steel hammer to dislodge dried cement from mixer).

Lightly grease all moving parts.

The gearbox is sealed for life. Do not attempt to open the gearbox and change the oil.This is not

necessary, and doing so will void the warranty. Keep the motor assembly clean and free of build

up. Wipe the on/off switch assembly and motor with a lightly dampened cloth. DO NOT spray water

directly onto motor. Protect motor assembly from rain. Store mixer indoors.

Please use caution when dumping the contents of the mixer. The motor should be in the OFF

position when emptying the mixer.

3. Cement mix instructions

Note: Refer to instructions from the cement mix manufacturer.

a) Turn power to off (“O”) position, disconnect

power cord.

b) Ensure drum is empty.

c) Positioned on side of mixer, grab front and

d) Move mixer to desired location.

lift rear leg of mixer off the ground. Be careful

not to tip mixer on yourself.

Method 2:

Method 2

METHOD 2

kobalttools.com