Use and Care Guide

ASSEMBLY INSTRUCTIONS

DO NOT COMPLETELY TIGHTEN.

6. Attach drum support arm (G) to handle (F) using

M8 × 40 mm bolt (DD) and M8 Nut (HH).

Assemble dump handle (J) to drum support arm (G)

using two M8 × 45 mm bolts (EE) and two M8

nuts (HH).

7. Assemble motor (N) to handle (F) and drum support

arm (G) using M8 nut (NN), M8 spring washer (PP)

and M8 flat washer (OO).

After aligning all holes from motor housing to drum support

arms properly, tighten all screws from motor housing to mixer

arm supports securely.

TIGHTEN ALL FASTENERS FROM STEPS 6 & 7.

8. Assemble U-Bolt (KK) to drum support arm (G) using

two M8 nuts (HH). Do not completely tighten.

Slide onto pivot pin (L).

Insert U-Bolt (KK) into handle (F). Attach two

M8 flange nuts (HH) to U-Bolt.

TIGHTEN ALL SCREWS.

HARDWARE USED

M8 × 40mm Bolt

M8 × 45mm Bolt

M8 Nut

M8 Flat

Washer

M8 Spring

Washer

M8 Nut

M8 U-Bolt

5. Assemble wheels (B) to mixer frame using shoulder bolt

(CC), M10 flat washer (BB) and M10 nut (AA).

Tighten wheel bolts.

Set mixer frame on level surface. Make sure cross member (E)

is steadily seated on the ground.

Slide end cap (II) onto rear leg cross member (E).

MAKE SURE ALL SCREW HOLES AND SCREWS ALIGN

PROPERLY. PROPERLY TIGHTEN ALL SCREWS USED IN

STEPS 1 - 5.

HARDWARE USED

M10 Nut

M10 Flat

Washer

Shoulder Bolt

End Cap

EE DD

kobalttools.com