Use and Care Manual

9
WALL MOUNT INSTALLATION
Applicable Model: CH7730SQ6-WM-XX (30”) / CH7736SQ6-WM-XX (36”) / CH7748SQ6-WM-XX (48”)
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
- Decide the location of the venting pipe from the hood
to the outside. Refer to Figure 8.
- A straight, short venting run will allow the hood to
perform more efficiently.
- Try to avoid as many transitions, elbows, and long
run as possible. This may reduce the performance
of the hood.
- Temporarily wire the hood to test for proper
operation before installation. If the hood does not
operate, check the circuit breaker or house fuse. If
the hood is still not working, disconnect power
supply and check the continuity of all wire
connections.
- Peel protective film off the hood (if any).
- Use duct tape to seal the joints between pipe
sections.
- If necessary, prepare back wall frame with cross
framing lumber for secure installation. Using
references on TABLE 2 and measurements on page
16-17, decide the level of the lumber. Refer to
Figure 9.
Hood Installation
CAUTION: Do not use an electric screwdriver.
Use hand tools only. Do not over tighten screws
as this many cause damage to the hood.
CAUTION: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. And use a protective covering to protect
cooktop and/or countertop from damage.
1. Use reference on TABLE 2 and measurements on
page 16-17, mark the leveling point of the hood.
Position mounting screws (provided) on the wall,
leaving 1/8” away from the wall as shown in Figure
10.
2. Optional step for adjusting hood-mounting bracket
height:
- Loosen hood-mounting brackets at the back of
the hood, adjust brackets and tighten screws as
shown in Figure 11.
3. Align hood-mounting bracket to the two screws on
the wall and hook hood into place. Tighten screws
to secure hood to the wall.
CAUTION: MAKE SURE THE HOOD IS
SECURE BEFORE LEASING.
Figure 8
Figure 9
Figure 10
Figure 11
Mounting Screws