Installation Sheet

Installation Guide SKU#27862, SKU#27863
USA/Canada: 1-800-4 KOHLER 1446232_8_A
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damage. This product is for indoor use only. Observe all local codes.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto a clean
and soft cloth to protect finish. Confirm all parts are included.
2. Install decorative rods (N) onto the bottom of the fixture.
3. Adjust iron chain (Q) length to desired height by removing excess links.
4. Install iron chain (Q) onto loop (P) and coupling (H) with chain end (J).
5. Adjust nipple (F) protruding height to the desired position and then tighten
nut (D). Secure coupling (H) onto nipple (F).
6. Thread wire (R) and ground wire through rod (O), loop (P), and lace wire (R)
and ground wire through iron chain (Q), coupling ring (I), canopy (G), coupling
(H), and nipple (F).
7. Install rod (O) onto the fixture then install loop (P) onto rod (O).
8. Lift fixture then attach mounting bar (B) onto outlet box with screws (E).
9. Trim excess cord to minimum 13” beyond canopy (G). Strip wire to 5/8” at the
end, and twist.
10. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten fixture
green or bare ground wire to the green or bare copper wire in outlet box with
wire nut (A) or fasten onto ground screw (C) on mounting bar (B).
11. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten fixture
natural wire with ridges or white wire to the white wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the tape seals
the end of wire nut (A), see diagram 1.
12. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten the
fixture lead wire without ridges or black wire to the black wire in outlet box
with wire nut (A). Wrap the wire connector with electrical tape so that the
tape seals the end of wire nut (A), see diagram 1.
13. Tuck wires carefully inside outlet box. Let the coupling (H) protrude the hole
on the canopy (G). Attach the canopy (G) onto ceiling with coupling ring (I).
14. Install fabric shade (L) onto socket sleeve (M).
15. NOTICE: Do not exceed recommended wattage. Rated Max 60 W, Type B.
(Bulb(s) not included).
16. Put a bulb driver (K) over the bulb and screw it into the socket. Then remove
bulb driver (K).
17. Repeat steps 13-15 for all shades.
18. Restore power to circuit at breaker or fuse box.
CLEANING: Please clean fixture with a soft and dry cloth ONLY. Clean glass with a
mild soap.
Phillips &
Flathead
Screwdriver
Slip Joint
Pliers
Small
Adjustable
Wrench
Wire
Cutter/stripper
Electrical
Current Tester
Electrical
Tape
Approved fastener
(Wire nut)
Electrical ta
p
e
Diagram 1
PVC tube