Installation Guide
Technical Information
Required Accessories
K-304-K Rite-Temp valve without stops, NPT connections OR ❑ NA
K-304-KS Rite-Temp valve with stops, NPT connections OR ❑ NA
K-306-KS HiFlow Rite-Temp valve with stops, NPT connections OR ❑ NA
K-304-KP Rite-Temp valve with PVC connections ❑ NA
Recommended Accessories
HiFlow Rite-Temp thin wall installation kit* 88526
* Required when using the K-306-KS valve in a fiberglass
or acrylic installation.
Optional Accessories
Forté deep roughing-in kit for Rite-Temp
valve (lever handles)
1025388
Installation Notes
WARNING: Risk of damage to the K-306-KS
valve assembly. When using the K-306-KS valve
in a fiberglass or acrylic installation, use the thin
wall installation kit (88526).
Install this product according to the installation guide.
Install Rite-Temp valve according to valve installation guide.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install straight pipe or tube drop of 7″ (178 mm) to 18″ (457
mm) with single elbow between valve and wall-mount spout.
1/2"-14 NPT
6"
(152 mm)
72" (1829 mm)
78" (1981 mm)
to Floor (Typical)
2-7/8"
(73 mm)
Sculpted
Traditional
5-1/4" (133 mm)
Sculpted
5-1/4" (133 mm)
Traditional
48" (1214 mm)
to Floor
(Shower Only)
6-3/8"
(162 mm)
10" (254 mm)
to Spout
(Bath Only)
Top of Bath
5-1/4" (133 mm)
4" (102 m)
6"
(152 mm)
3"
(76 mm)
For slip-fit spout, tubing must
extend 2-1/8" (54 mm) Min;
3-1/2" (89 mm) Max beyond
finished wall.
For 1/2" NPT spout, pipe
must extend 4-1/2" (114 mm)
beyond finished wall.
Product Diagram
FORTÉ
®
FORTÉ
®
BATH & SHOWER TRIM SET
Page2of2
1018257-4-
H